Recent content by bckane

Just put my MarsAqua up yesterday, made brackets out of 1"Aluminum Rectangle Tube. The ligths are 14" above the water line.........wish the dail had an dial indicator....dont have a par meter............how is everyone doing the % setting on the on the dial.....

Thanks for the tip alb_56 I went ahead and ordered one................http://www.ebay.com/itm/121334978054?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649

looks good, I think I will pickup one of these

something like this http://www.homedepot.com/p/EcoSmart-100W-Equivalent-Daylight-5500K-Spiral-Full-Spectrum-Craft-CFL-Light-Bulb-ES5M827FS/100687004

is this the bulb you are talking about http://www.homedepot.com/p/EcoSmart-90W-Equivalent-Daylight-5000K-BR40-LED-Flood-Light-Bulb-ECS-BR40-90WE-CW-120-DG/204834056?N=5yc1vZbm79Z4b8

I would also like to get a few small pieces of xenia, to start off.........Miramar area TIA

I was using one of thesse, but need to get a new bulb......justs wondering if i should just get a new setup ....http://lightsofamerica.com/en/Products/9266.aspx

Redoing my sump. looking for a new light for my refugium.....? should I go LED.?

I think I know what these are used for, where the screws stick out from the bottom plate.?

Just picked up the SCA 302 skimmer.................have a few questions. I have the skimmer running in a bucket of salt water, and the water is only going up to the red disc plate above the pump...........the skimmer is in 7" of water.......???? And are these spacers go somewhere...

Just asking if it safe to use pvc glue to build my skimmer stand

I need to make a skimmer stand, Im using eggcreate and PVC is it ok to use pvc glue for the joints.? this is in sump skimmer

went to several LFS in my area.........all around $45-50

Guess I will wait for a good sale

going to check my LFS before I place an order.........have several buckets, just looked like the boxs were a bit cheaper