Recent content by tronyony

  1. T

    Minimalistic multichip DIY LED build

    Yep, I use Arctic Silver 5. Tony
  2. T

    When calibrating my pH probe...

    That's actually pretty close to what mine is. Temp plays a role in Ph from what I've read. Mine is 7.99 right now
  3. T

    When calibrating my pH probe...

    Rog. What's your reading on the Ph probe?
  4. T

    When calibrating my pH probe...

    Just a thought but when I first connected my probe I had it on the wrong port. plugged it into the Ph port instead of the Ph/Orp port and butter baby. Tony
  5. T

    LED's flicker

    Russ, Here is what Meanwell said about the dimming circuit on my Meanwell HLG-80H-48B drivers: "It is less than 0.15 mA for per unit." Thanks, Tony
  6. T

    When calibrating my pH probe...

    No sir. Just my own experience. My coral don't mind the temp and my fish are cool withi it too. Tony
  7. T

    When calibrating my pH probe...

    Its actually where I like it. I used to keep it at 79° . At 84° every thing is groovy
  8. T

    When calibrating my pH probe...

    My Ph after close to an Hr of adding the 8.2 Ph buffer Tony
  9. T

    When calibrating my pH probe...

    I really didnt go crazy with the cleaning. When It stopped dropping I shook the solution again. Probably about 3 times I did that. When it stopped droppen and stayed I said guess thats close enough. Switched to the 10.0 and did the same thing. Tony
  10. T

    Need Help ASAP!!!!

    Sonny, check your PM
  11. T

    When calibrating my pH probe...

    Mine did that not 15 min ago when I calibrated mine. I pulled the probe out cleaned it, shook the solution and put it back in. It got down to 7.24. Called it good. repeated the steps with the 10.0 solution. stuck probe in tank and it read 7.82. Added some 8.2 Ph buffer and the display is...
  12. T

    LED's flicker

    I e-mailed Meanwell and asked if they know the mah draw on the dimming circuit. Waiting to hear back from them. I also e-mailed Neptune with the same information I've provided here. Still waiting to here back from them. Side note, I have 2 drivers connected to one VS port and there is no...
  13. T

    Meanwell drivers and APEC controllers

    Hi everybody. I have a bit of a situation trying to ramp up and down (dim) my DIY LEDs/drivers with the Apex controller. I have constant flickering if I have more than one driver connected. Here is the thread I started about it in the Neptune section...
  14. T

    Minimalistic multichip DIY LED build

    That's a big 10-4. Will do it shortly. Thank you. Tony
  15. T

    LED's flicker

    I can measure it if you can tell me what to use. I have a wattsup meter for my RC stuff. Measures volts, amps and watts in line with the source and the load. Will this work or do I need something else?
Top