10 gal aio diy nano office tank

freddielake

New member
Here is my 10 gal AIO. Tank was a Petco 10 gallon tank, all of the plastic was removed and all corners were sealed with silicon. Filter box was made to size and sealed and put in before water was added. Copepods live in between the glass and the filter box.

First few pictures were taken about 1 month after it was cycled. Last pictures were taken this morning.

Tank has been running since end of 2018.

1 storm clown 1 six line wrasse

-Screen lid was made out of parts from Lowes.

-Aqueon 50w heater

-Small NANO return pump from Amazon.

-Media is carbon in the bottom with bio balls and filter floss in a DIY media tray.

-Radion gen 2 XR30 on SPS AB+ 25% from 7:30AM to 5:15PM everyday.

Livestock:

-Zoas all different species best is my JF rainbow incinerators

-Octospawn

-Frogspawn

-Hammer

-2 JB mushrooms

-Red plating monti

-Purple plating monti

-JF green and red grafted monti

-Duncan

-Trumpet

-Florida Ricordia

-GSP

-Meat coral

-Scoly

-Mystic sunset
 

Attachments

  • 57486825770__570C202F-652A-46EB-B389-461D4A29C0AB.jpg
    57486825770__570C202F-652A-46EB-B389-461D4A29C0AB.jpg
    76.1 KB · Views: 1
  • IMG_1511.jpg
    IMG_1511.jpg
    60.3 KB · Views: 2
  • IMG_1512.jpg
    IMG_1512.jpg
    43.6 KB · Views: 2
  • IMG_1513.jpg
    IMG_1513.jpg
    64.1 KB · Views: 2
  • IMG_4252.jpg
    IMG_4252.jpg
    52.3 KB · Views: 2
Looks good your a brave one removing all the reinforcement plastic trim. Those are made out of 1/8inch glass and imo not the strongest

Sent from my SM-N960U using Tapatalk
 
looks great. want to do that to a 20. where did you get the acrylic for the back wall?


use a heat gun to remove the trim and sand the edges round
 
Back
Top