ctniners
New member
I am getting ready to start a new project and for my water station I want to use a ro/di shut off valve....here are my questions
1. When you use it to fill up your container, do you leave the water valve (from the house pipe) to the ro/di unit always on? or do you leave it on until is filled and shut it off after the container is full?
2. Maybe this is only happening with my ro/di unit but every time i have to make water it takes about 5 minutes or so (maybe a little less) for the water to hit the 0 tds mark...when you guys make water, do you unhook the tubing from the shut off float valve to drain the first water that comes out or do you just leave it hooked up to the container all the time and dont worry about it.
maybe silly questions but i rather ask...thanks a lot for the help
1. When you use it to fill up your container, do you leave the water valve (from the house pipe) to the ro/di unit always on? or do you leave it on until is filled and shut it off after the container is full?
2. Maybe this is only happening with my ro/di unit but every time i have to make water it takes about 5 minutes or so (maybe a little less) for the water to hit the 0 tds mark...when you guys make water, do you unhook the tubing from the shut off float valve to drain the first water that comes out or do you just leave it hooked up to the container all the time and dont worry about it.
maybe silly questions but i rather ask...thanks a lot for the help
Last edited: