sfsuphysics
Active member
Just happened when I switched over the the new 3.4(?) firmware not too long ago. pH graph works fine, temperature graph however doesn't show up at all. It did initially now it won't. Shows up fine if I use aquanotes however.
I tried to flush the memory and that allowed the temp graph to show up for about a day, then poof away it went again. Looking at the datalog I don't see any "invalid" entries for temperature either it shows them all.
Any ideas?
I tried to flush the memory and that allowed the temp graph to show up for about a day, then poof away it went again. Looking at the datalog I don't see any "invalid" entries for temperature either it shows them all.
Any ideas?