Alarm going off

shawn1965

New member
Good evening - The alarm is going off on my 7095 controller. I have clean the 6100, that did not take care of it, Then I soaked everything apart in vingear for about 20 hours. I done everything that your post said to do, and the alarm is still going off. Any other suggestions .
 
The controller doesn't have an alarm, it is the pump driver. Be sure that the upper bearing is not stuck to the magnetic rotor.
 
Is the upper bearing the piece with the o-ring, that you pull out with at 5mm screw. If so, I pulled that out and also soaked it in the vingear. I also pulled the thin wall bushing right under the propeller and soaked it also. Thanks Shawn
 
If all pieces are clean than there is likely an electrical fault, provided that it didn't get wet it would be warranty. Just send it in and we will get it repaired ASAP.

Tunze USA
1304 Monica St
Austin TX 78758
 
Thank you very much, Do I need to send in my receipt of purchase, do I need a reference number. I will get everything out tommorow , Thanks for your help.
 
Back
Top