tgunn
New member
Hey all,
I've about had it with the piece of crap Won Bros digital heaters I've got.
I have three.
I've already had one in for repair because it was reading 120F all the time. Today I was about to close off my QT tank where my spare rocks were sitting from my big overhaul. Well, despite being set to 79F and READING 79F on the dial I stuck my hand in and thought, "Hmm, that's not right".. Turns out the calibration just went WAY off on the heater. Because the water is around 70F.
SO, what I'm wondering is, does anyone know if I can just cut off the crappy controller and use the titantium part as a heating element? Then I could just wire it up to a RELIABLE Ranco and have a heater that doesn't suck.
Any ideas?
Tyler
I've about had it with the piece of crap Won Bros digital heaters I've got.
I have three.
I've already had one in for repair because it was reading 120F all the time. Today I was about to close off my QT tank where my spare rocks were sitting from my big overhaul. Well, despite being set to 79F and READING 79F on the dial I stuck my hand in and thought, "Hmm, that's not right".. Turns out the calibration just went WAY off on the heater. Because the water is around 70F.
SO, what I'm wondering is, does anyone know if I can just cut off the crappy controller and use the titantium part as a heating element? Then I could just wire it up to a RELIABLE Ranco and have a heater that doesn't suck.
Any ideas?
Tyler