Controller

[bertcmg]

Roger, I recently noticed that the flow in my tank was lower than usual, so I some maintainence ( calcification and the usual)

Eventualy I have come to find that the second channel on my multicontroller has ceased to work.

My pumps work at full capacity when they are running without the controller so I know that the pumps and their components are not the issue.


Can you advise as what I can do to fix/ diagnose it

btw I have the older model multicontroller.

 

[rvitko]

I would make sure the cable is well connected and try disconnecting power for a minute to see if that doesn't fix it.

 

[bertcmg]

Tried that, Still the same issue, both channels work if I use the sequantial setting tho

thanks for the quick response

Bert

 

[rvitko]

It is difficult to say what could be the cause, the 7094 is no longer made so it is hard to get the parts to fix them. It could be the switch for your settings isn't working right. I know it can also happen that if a weaker pump (6000) is on the second channel it can cause eratic behavior from not enough power.

 

[bertcmg]

I guess thats it, I am running a 6100 and a 6000 otherwise I now have an ligit excuse to upgrade