Korallin 1501 little help

[redstile]

I have a reactor korallin 1501, every 8/10 gg I find I accumulate of co2 ca 1 cm, the regulation now is of 50 bpm and 2,0lt/h in exit, which modifications to the regulation are necessary in order to eliminate the problem?
thanks to all

 

[redstile]

sorry but nobody use this calcium reactor or have a problem whith us

 

[crab0000]

I normally use the #2 outlet as my main outlet so any CO2 that builds up just goes out the outlet.
Steve

 

[redstile]

<a href=showthread.php?s=&postid=7058642#post7058642 target=_blank>Originally posted</a> by crab0000
I normally use the #2 outlet as my main outlet so any CO2 that builds up just goes out the outlet.
Steve

ths crab0000, excuse the outlet #2 is the same one from where exits enriched water of calcium ?

 

[-=DieselDave=-]

I believe Crab0000 is referring to the outlet in the center of the top. I use that one only as well.

 

[redstile]

dieseldave the outlet in the center how much you hold it opened?

to leave it open does not lose pressure ?

thanks

 

[crab0000]

<a href=showthread.php?s=&postid=7058973#post7058973 target=_blank>Originally posted</a> by -=DieselDave=-
I believe Crab0000 is referring to the outlet in the center of the top. I use that one only as well.

That's correct. I had a problem with CO2 build-up as well when using it as describred in the instructions, so I switched which outlets I yse and no longer have a problem.

<a href=showthread.php?s=&postid=7066018#post7066018 target=_blank>Originally posted</a> by redstile
dieseldave the outlet in the center how much you hold it opened?

to leave it open does not lose pressure ?

thanks

I leave mine open however far I need to to get the right drip rate. I don't think it should be pressurized, so it shouldn't be a problem leaving it open.
Steve

 

[redstile]

thanks I try to open little outlet #2 without to influence on the drip rate