LED Light and Dual Spectrapure DI

janes_mw

Active member
Custom build LED light. It is a Reef LED Lights supplied parts build. Custom build LED heatsink, LEDs, Carbon Fiber Housing (with ends). Wired for 4 channels. LEDs consist of:
Channel 1 - 11 Violet (cree)
Channel 2 - 22 binned cool white (cree)
Channel 3 - 27 royal blue (cree)
Channel 4 - 6 blue (cree)
Carclo Optics on all.

48V, 7.5A AC/DC PSU Regulated Switching Power Supply S-360-48 (360W)

2ea. 5 channel , Meanwell drivers so you can change the arrangement to more channels if you want by moving wires.

Coralux Storm X LED Controller. 16x2 Character LCD Display, 16-channel 12-bit PWM 90-5V), 4096 Dimming levels, Real time clock, Manual Sunrise/Sunset Time, Geolocated Sunrise/Sunset, Staggered Sunrise/Sunset Delays, Moon/Lunar Phase Simulation, SmoothRamp Dimming and Clouds, Lightning Storm Effects, Arduino Compatible, PC Fan Control, LCD is auto-dimming.

18.5 inches long, 9.75 inches wide, 4.5 inches tall. This will easily light a nano at 1/3rd power. High end/bin LEDs.

Don't ask what this thing cost in components as it hurts!

Ran for 48 actual hours over my frag tank. The only reason I changed was because I got an LED that matched my 300 setup (cosmetics only).

Over $650 in components, $150 OBO, plug and play.







Spectrapure Dual Reactor with refillable cartridges and dual TDS. It was set up for dual DI. I have two of these, so this one for sale. $40

 
Nate good choice on light highly recommend it as I have seen it. Mike I will take spectrapure
I have the d120 I got from you retrofitted into the biocube hood. But now I'm like light paranoid haha

Sent from my XT1254 using Tapatalk
 
Back
Top