Light blinking Too Low

[RickD63]

Controller is blinking Too Low. I've unplugged and plugged the power back in and still the same issue. The controller will pump for about 10 seconds then stop.


Sent from my iPad using Tapatalk

 

[rvitko]

If only the too low light is on, this means it was erased, the 10 minute timer is zero minutes so right after the start up cycle it goes to too low. We can typically repair this, it will need to be reprogrammed. The most common cause is a power surge or repeated harsh and rapid switching on and off, but water damage and age (usually more than 8 years) can be causes that may not be repairable.

 

[RickD63]

Thanks Roger. Let me know where I should send it. I'm hoping it's nothing serious. I don't see signs of water damage. Thanks.

 

[rvitko]

Tunze USA
2121 Cole Springs Rd
Buda TX 78610

 

[RickD63]

Thank you sir! I just mailed it.