Looking for Power Supply PCB Design and components?

[Aqualund]

I'm wondering if anyone is saavy enough to lead me in the right direction to design a 110VAC In to 52VDC 700mA Out power supply chip on a small pcb board, or even a dc to dc stepup board to get me 10 52VDC 700mA.

I want to modify my old ecorays to make them dimmable, and I would like to use the new meanwell ldd's but finding the right power supply is proving quite difficult!

I can read a schematic and put the parts together if I'm told what they are My circuits class isnt until spring!

 

[mcgyvr]

There are TONS of off the shelf 48V power supplies to use with a meanwell LDD
http://www.mpja.com/48-Volt-Power-Supply/products/544/

or just buy a single meanwell LPF-40D-54 and a 100k potentiometer and you are done.
http://www.meanwell.com/search/LPF-40D/default.htm

 

[Aqualund]

Thnx Mcgyver! Like you, i found a lot of those, but I feel they are too big(siz). I would want something that can fit inside the current footprint or smaller. Additionally, I would prefer to mirror the existing output voltage as much as possible, which is 52VDC. I would imagine based on my math that in their parallel configuration, every volt is needed because of the 1w led drop voltage. But, for arguments sake I will try to grab a 48VDC ps from somewhere and see how it works as a starting point!