ScottB
New member
I am trying to configure my 2xMP10s to run the EcoSmart modes (TS, NTM) with my apex controller. When I put the main in either TS or NTM, I would expect them to behave as the manual says and the master go to purple and the slave to flash between white/orange/turquoise (sync, anti-sync, back).
That does not happen. Whichever mode the slave was in previously, that is the mode it remains in and never cycles as far as I can tell. Is this flashing a rapid thing, or are we talking every 10 minutes, every hour, or what?
Have any of you fine folks ever successfully done this with an APEX controller?
That does not happen. Whichever mode the slave was in previously, that is the mode it remains in and never cycles as far as I can tell. Is this flashing a rapid thing, or are we talking every 10 minutes, every hour, or what?
Have any of you fine folks ever successfully done this with an APEX controller?