perikaruppan
Member
I purchased this MP40WeS from US and it has been working perfectly.
But when i reset my tank, had to remove the MP40EwS and both the magnets got stuck to each other without a preventive layer inbetween.
Installed it back into the tank, and it just turned on for a few seconds and then ithe controller is blinking Red and Green continuously.
I cleaned the Wet Side, and put it back in, turned on. But still same Error.
Did i do something wrong? what can be done to solve this.
I am not in the US. So shipping it back and forth is going to be an expensive proposition.
kindly help
Peri
But when i reset my tank, had to remove the MP40EwS and both the magnets got stuck to each other without a preventive layer inbetween.
Installed it back into the tank, and it just turned on for a few seconds and then ithe controller is blinking Red and Green continuously.
I cleaned the Wet Side, and put it back in, turned on. But still same Error.
Did i do something wrong? what can be done to solve this.
I am not in the US. So shipping it back and forth is going to be an expensive proposition.
kindly help
Peri