Ron Popeil
Love them clownfish.
i have a PM calcium reactor ive had for a few years and it worked great, for the most part. i decided to make it reverse flow a few weeks ago but have had problems now maintaining CO2 levels inside the chamber.
the design is very similar to this with one change:
instead of the bubble counter that goes up and then Ts into the pipe, i put just a T and have the CO2 go directly into the pipe.
my regulator now isnt able to keep a continuous flow of C02 going. it is a milwaukie regulator, and in the past ive always adjusted the macro knob to 20 lbs and then used the micro knob for a steady bubble per second. now what happens is the bubbles slow down and eventually stop coming out.
no amount of adjusting the macro and micro knobs will now allow a continuous stream of CO2. what gives? what ideas or suggestions are out there?
thank you!
the design is very similar to this with one change:
instead of the bubble counter that goes up and then Ts into the pipe, i put just a T and have the CO2 go directly into the pipe.
my regulator now isnt able to keep a continuous flow of C02 going. it is a milwaukie regulator, and in the past ive always adjusted the macro knob to 20 lbs and then used the micro knob for a steady bubble per second. now what happens is the bubbles slow down and eventually stop coming out.
no amount of adjusting the macro and micro knobs will now allow a continuous stream of CO2. what gives? what ideas or suggestions are out there?
thank you!