screwed!

[wiggie89]

I am in a real tight jam. I bought an ro/di and went to install it tonught and somthing bad happened. I lost the directions. I know it sounds stupid but i think they where thrown away. It is a wps 6 stage with watrer drinkng kit. I dont know where the tank goes and I am not sure about the lose ends to the hoses. I know there is no real way you can help me put please just give me som advice.
Justin

 

[2crazyreefers]

I believe they should be connected as follows. Sink to prefilter to carbon to membrane to DI. You must have 2 of some of these which I believe should be connected to each other in a row. IE membrane to membrane to DI to DI. Hope this helps.

 

[BeanAnimal]

Where did you buy it and what model is it?

 

[hllywd]

I know it doesn't help over the weekend but give them a call, I'll bet they'll be more than helpful to send you new instructions... probably fax them to you if you have a machine.... or possibly on there website...
good luck!!!

 

[RobbyG]

For A 6 stage system:
Pipe water (TO) 3 stage Prefilter (TO) RO Filter (TO) DI Filter (TO) Carbon Filter then attach Carbon output with "T" fitting to Pressure Tank on One side and Water Nozzle on other.

On one side of RO membrane will be the input on the other side will be two connections, the one nearer the center is the output which goes to DI filter, the other nearer the edge is the waste water line which goes to restrictor and then to waste drain pipe.

 

[fahz]

 

[hllywd]

That should help!!!:thumbsup:

 

[wiggie89]

Wow thanks alot
You all helped me do it,
really apreciat it