Parts Needed
2) Aqualifter Pumps
1) Timer with 15 minute increments (like the little buttons)
http://www.hydroponics-hydroponic.com/images/000_0515.jpg
2) .5 GPD Sprinkler Drippers
1) Drain
1) Splitter to plug both Aqualifters into the single timer
1) Water Source
TUBING!
Now to set it up:
Get both aqualifters and plug both into the timer
Attach tubing and the .5 GPH dripper to the end of the output
Put the inlet of one in the Fresh SW and the out put of that one DOWN-CURRENT of the Bad Water inlet
Put the Bad Water out near your drain/ outside through the wall like I will
Now if you want to change 1.5 GPD take that figure and you will need the pump to be on for 3 hours throughout the day. Set the timer to come on for 15 minutes every hour for 12 hours or figure out your application. You could even use the 1 GPH drippers to have it on half as long.
Thanks
I will be using this on my next setup and will get pics then
2) Aqualifter Pumps
1) Timer with 15 minute increments (like the little buttons)
http://www.hydroponics-hydroponic.com/images/000_0515.jpg
2) .5 GPD Sprinkler Drippers
1) Drain
1) Splitter to plug both Aqualifters into the single timer
1) Water Source
TUBING!
Now to set it up:
Get both aqualifters and plug both into the timer
Attach tubing and the .5 GPH dripper to the end of the output
Put the inlet of one in the Fresh SW and the out put of that one DOWN-CURRENT of the Bad Water inlet
Put the Bad Water out near your drain/ outside through the wall like I will
Now if you want to change 1.5 GPD take that figure and you will need the pump to be on for 3 hours throughout the day. Set the timer to come on for 15 minutes every hour for 12 hours or figure out your application. You could even use the 1 GPH drippers to have it on half as long.
Thanks
I will be using this on my next setup and will get pics then