Stream 6080 and a controller?

[JRic999]

This may be a stupid question but what will happen if I were to hook up 2 6060 or 6080 streams to a single controller or multicontroller? I know that the speed wont increase and decrease but will they still do the pulsing, wave simulation, and switch back and forth? Will the feeding and nighttime modes still function?
Thanks,
Jeremy

 

[rvitko]

It isn't possible as the single controller and multicontroller connect to a 5pin DIN port which isn't present on the 6060 or 6080. The pumps wouldn't respond to the controls even with the accesory socket 7094.40 and likely it would ruin the pumps. These pumps can only be run at one hour off and on intervals on timers. You could also use our foodtimer 7602 to turn them off for feeding

 

[JRic999]

thanks