drinkhomebrew
New member
I am using the drain pipe/ over flow calc. I want to drill a hole in my tank and install two bulk heads. When I put 1100 gph in the calc it comes back with:
Using the following input parameters
Gallons per Hour = 1100
Drain and Overflow sizes are calculated as
Recommended minimum drain pipe diameter = 1.37 inches
Recommended minimum linear overflow size = 17 inches
Does this mean that if I have two one inch bulk heads and make a over flow that is at least 17 inchs long their will be enough water flow through the drain?
Using the following input parameters
Gallons per Hour = 1100
Drain and Overflow sizes are calculated as
Recommended minimum drain pipe diameter = 1.37 inches
Recommended minimum linear overflow size = 17 inches
Does this mean that if I have two one inch bulk heads and make a over flow that is at least 17 inchs long their will be enough water flow through the drain?