kentuckyclowns
Member
So I'm looking to re-wire my DIY LED setup because I fried a few lights (most likely too high on my driver setup) but wanted to know if there was a better/more efficient way to wire up the A/C and D/C power going to my meanwell drivers.
In case you are not familiar with the 60-48D versions, they require a 10V max DC input as well as a standard A/C input. Since I'm not good with electrical concepts, I followed the step-by-step instructions and repeated that 4 times, once for each driver. Now, I have 4 A/C plugs and 4 D/C plugs controlling the 4 meanwells. Can I simplify this? Aka, can I use 1 A/C plug to control all 4 drivers and 1 DC plug to control all drivers, without the risk of losing the required voltage to power each driver?
In case you are not familiar with the 60-48D versions, they require a 10V max DC input as well as a standard A/C input. Since I'm not good with electrical concepts, I followed the step-by-step instructions and repeated that 4 times, once for each driver. Now, I have 4 A/C plugs and 4 D/C plugs controlling the 4 meanwells. Can I simplify this? Aka, can I use 1 A/C plug to control all 4 drivers and 1 DC plug to control all drivers, without the risk of losing the required voltage to power each driver?