ACIII with wireless ethernet bridge

[uberlink]

hi there,

I just received my new ACIII, and I'm trying to configure it for use with a Linksys WET54G wireless ethernet bridge. To make matters slightly more difficult, I'm trying to do it using a macintosh and an Airport wireless network.

I'm not sure what the setting should be on the wireless router and on the ACIII. I don't know what I should be using for the IP address, the netmask, the gateway, or the DNS server...on either the ACIII or the ethernet bridge.

Has anyone done this before? Any help would be greatly appreciated!

-Mark aka uberlink

 

[uberlink]

Hey, I figured it out. Thanks anyway.

 

[SERVO]

Please post the steps you took to configure your aquacontroller so others may learn.

Thanks

 

[uberlink]

I can't tell you how I did it. It was too much trial and error. I'll try to recreate it at some point soon and post it all here.

Unfortunately, I still can't get it up on the internet, so I may still have some incorrect settings!

 

[lvreefer]

<a href=showthread.php?s=&postid=11238203#post11238203 target=_blank>Originally posted</a> by SERVO
Please post the steps you took to configure your aquacontroller so others may learn.

Thanks

start with this and will go from there.

Sorry but it might take me a day or two to get back to you, travel and all.

 

[uberlink]

I figured it out. Here's the thread. Thanks for your help!

http://www.reefcentral.com/forums/showthread.php?threadid=1256946

 

[Deleted member 7065]

Wireless bridges are really easy - - follow the instructions with your bridge then plug it into the Neptune. The bridge is transparent to yoru Neptune. it is like going to the router. It is that easy - and trust me I screw up everything else with my network.