APEX coding help? new ATK keep sending text alarms

[m0nkie]

Hello. I'm not good with these APEX codes. Please help me figure out why I keep getting text alarms all night.

I setup the ATK and used the given codes provided by APEX. the unit is working, but It's sending chain alarms. the tank at that time shouldn't have any feed or anything going to change water level dramatically

Fallback OFF
Set OFF
If Swx8_1 OPEN Then ON
If Swx8_2 CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF

 

[mtnbike101]

Check this thread: Apex is Alarming

or here

 

[cal_stir]

What is your alarm statement?

 

[m0nkie]

What is your alarm statement?

FRM:Apex Fusion
SUBJ:Apex Fusion Alarm: apex
MSG:Status: ON
Statement: If Swx8_2 CLOSED Then ON Date: 2022-12-15 14:44:32 -0800

 

[minus9]

Switch the sensors positions and see if the alarm follows that sensor. If it does, it's the sensor. Their optical sensors don't last long. I've replaced both and one of them twice.