Hi,
I have an automatic feeder(120v). Feeder is not on timer,just activated by manual control on apex.Feeder turns from a power signal ,runs for few seconds and will not run again until power is cycled off then on.
I'm trying to figure out a way to turn off main pump 2min before I feed and stay off for add'l 15min.Also if water level hits hi level float, turn back on regardless.
Any help setting up a list of commands would be greatly appreciated.
Thanks
I have an automatic feeder(120v). Feeder is not on timer,just activated by manual control on apex.Feeder turns from a power signal ,runs for few seconds and will not run again until power is cycled off then on.
I'm trying to figure out a way to turn off main pump 2min before I feed and stay off for add'l 15min.Also if water level hits hi level float, turn back on regardless.
Any help setting up a list of commands would be greatly appreciated.
Thanks
