Control port, X10 and LunarSim

[Hawkdl2]

Is there any way to expand the Apex control port so that I can run both a lunarsim moonlight and an X10 PL513 interface? Both need the control port on the base unit. Is it possible to build a "Y" RJ11 cable that would split to two devices? Is it possible that the signals sent by the Apex to either device would be ignored by the other?

 

[Deleted member 143833]

Did you try connecting the out of the Apex to the In of the LunarSim and then the out of the LunarSim to the in of the Line interface?

 

[Hawkdl2]

Looking at the LunarSim device would have been too easy. I assumed it was a terminal connection. I'll hook it up and see if it works.