mrichardson
New member
Ok I have a problem....
I just got my tank back from the guy who drilled it, and upon taking it out of my truck the bottom of the tank caught and a small piece of the molding on the bottom of the tank snapped off. It was a clean break to where I could glue it back.
My questions are:
1.) What kind of adhesive [could / should] I use, to adhear the molding to itself and the glass portion of the tank it was hiding?
2.) Will this affect the structural integrity of the seals of the tank? The piece of molding came off of the left back corner.
3.) Will this affect the structural integrity of the footing of the tank? I do not want the segment to break off upon adding 1000lbs of water and cause the rest of the molding to smash, and the tank slip.
Thanks all.
I just got my tank back from the guy who drilled it, and upon taking it out of my truck the bottom of the tank caught and a small piece of the molding on the bottom of the tank snapped off. It was a clean break to where I could glue it back.
My questions are:
1.) What kind of adhesive [could / should] I use, to adhear the molding to itself and the glass portion of the tank it was hiding?
2.) Will this affect the structural integrity of the seals of the tank? The piece of molding came off of the left back corner.
3.) Will this affect the structural integrity of the footing of the tank? I do not want the segment to break off upon adding 1000lbs of water and cause the rest of the molding to smash, and the tank slip.
Thanks all.
