DIY Swabbie

i think the spraydown bars like on the bubble kings they use a small high pressure pump for this, they have quiet the setup for theyre self cleaning cup though and would take 3-4 controlled outlets on a controller to make work, i think they have a float switch when tripped when the cup is about full it injects water into the cup raising the water level in the cup creating a siphon to drain the cup and then shuts off.
 
and that isnt a diy in the first video they sell that whole skimmer lid with swabbie for $130, they just added the spray bar

The head of the unit is no doubt from our shop, the rest looks to be DIY. There is a stand off system used here, I presume to keep the motor from getting wet. The Swabbie uses a 4 point seal to keep the water from entering the motor housing where the kalk head unit is just a 1 point seal. We used the kalk head as the starting point of the design for the Swabbie, looks like mr714albert did the same thing :-)

If mr714 is in the RC house, please speak up. I will send a proper shaft seal to you, so you don't start any fires or prematurely corrode the motor.
 
I would venture a guess that they had or purchased a smaller unit and retro'd it to a larger skimmer lid. The wash down really doesnt look like it would do much.

ps: Love my Swabbie!
 
Back
Top