Does the Mp10 wes need a rubber gasket?

[PirateLove]

Hi Rc. I have a mp40 and it has a rubber gasket that goes on the outside of the tank. Does the MP10 wes also need one?

 

[rtparty]

Only if your glass is thin enough. I can't remember the number off the top of my head but I think it's around 1/4" and under? I'll have to look

 

[PirateLove]

I am trying to find the information on the website but have not been successful.

 

[rtparty]

I am trying to find the information on the website but have not been successful.

It's in the manual. I think I read 3/16" and below need the spacer. What thickness is your glass?

 

[PirateLove]

It's in the manual. I think I read 3/16" and below need the spacer. What thickness is your glass?

rtparty thank you very much for the help. I measured my glass and it is 3/8". I do not need the rubber spacer.

Thanks again!

 

[FullBoreReefer]

I figured it would help cut down on vibrations or help keep it from sliding.

 

[PirateLove]

I figured it would help cut down on vibrations or help keep it from sliding.

I have it on my glass with no spacer now and it looks like it is not even. The dry side is lower than the wet side. It does look like it is sliding.

 

[FullBoreReefer]

I have it on my glass with no spacer now and it looks like it is not even. The dry side is lower than the wet side. It does look like it is sliding.

It's just what I thought it was used for, not saying I'm correct