Dosing pump used to increase ph ?

[redfsh101]

i am setting up a Kalk reactor and was wanting to use the dosing pump to control the ph can the dosing pumps be set this way or only through the power bar .

 

[kidney514]

That should not be a problem.
Just program you dosing pump to be assign to the socket you want and then configure that same socket to "PH-value 1" and the other to "Increase"

PS By the way it's all in the manual

 

[Matthias Gross]

Like kidney514 already mentioned:
The dosing pump is handled like a socket.
That means: The pump can be assigned any function you like. Usually you use the function "dosing" or "timer", but you can assign the function "pH increase".

In this case I recommend to use one of the advanced control operation modes.
The standard mode is "2point control" works with hysteresis. This is a simple mode which works fine in most cases.
(BTW: this is the only mode other controllers support).
ProfiLux has additionally the "pulse-pause modes". They are very useful if you want to influence a value and this value reacts very slowly. Please read more in the manual regarding this.