Feeding Pause on all the time.

[cagri]

I set up my ProfiLux yesterday, it was running fine until this am around 9:00am.

After that it went into feeding pause mode, and no matter what I do I cannot get it out of it, is there a setting somewhere I am missing???

Thank You
Cagri

 

[kidney514]

If you press esc (on device) again. it should get out of the feeding pause....

Then go check how much time you have allocated to the feeding pause.

 

[cagri]

I did that, and then seconds stops(they dissapear), but then FP still displays on the top left hand corner, I cannot get rid of it, turned on off the unit, but it still says FP.

 

[cagri]

ok I just checked on it again, and it is not there anymore and everything is functioning right. What might cause this to happen out of nowhere? I did not activate it, it just got turned on by something but I don't know what?

 

[cagri]

ok it is 9:40 and FP sign showed up again, I did not touch anything, it shows up out of the blue, any reason why? and I cannot get it out of this mode, until it decides it is done. I am on firmware 4.00.

THanks

 

[kidney514]

I would try to upgrade to the current version and see if the problem persist! Current is 4.02

 

[cagri]

ok I figured it out, on one of my timers if active then feeding pause was checked, that is why.... all is well.

 

[kidney514]

Thanks for sharing the source of the problem.....