Jbj ato

[Marchillo]

i have this setup in the third chamber of my sump. One float valve is attached to the second to last hole on the bracket and the other is one above. Someone else set this up for me and it was set to mode B. After looking online it looks like they recommend mode A. It appears in mode B the switches are even on the bracket which is not how I have them. Any recommendations on which mode and pros and cons would be appreciated.

Thanks Steve

 

[laga77]

I assume you have a reservoir. Then, it should be in mode "A", with sensor 1 in your tank and sensor 2 in your reservoir.

 

[Bpb]

I like running mine in mode A, with the "reservoir" switch mounted upside down and sitting level next to the other switch that way I have a fail safe off option in the event the first switch sticks on

 

[Marchillo]

I like running mine in mode A, with the "reservoir" switch mounted upside down and sitting level next to the other switch that way I have a fail safe off option in the event the first switch sticks on

So I have a double float bracket. So sensor one sits in one hole and sensor two sits in the hole next to it not a level up. Except sensor 2 is placed upside down. I set it to mode A and when evaporation occurs the pump fills up and stops at sensor one. If sensor one fails it rises just a little more and stops at sensor 2

Is this correct? I like it.

Much better than my setup now.