Leveling 265 reef tank

[Big gun]

Hi guys I need help I just got done completing my stand for my 265 just getting ready to set the tank and decided to check the stand . Not sure how this happened but across corners the stand is out 1/4 inch I am sick the stand is a built in no moving it would it be ok to remove the top shim the whole top and replace the top or do I need to waste all that work and money and tear it down and start over

 

[S14Swap240sx]

im confused by what ur describing.. can you just throw a composite shim under the stand u built?

 

[dkerns06]

I would consult a carpenter but it seems like that would work. Shim it up around the top and use wood putty if you need to fill any gaps aesthetically.

Sent from my LG-P999 using Tapatalk 2

 

[Big gun]

No can't shim at floor the stand is screwed into concrete the only two thing I can do is remove the 3/4 oak plywood off the top and shim the top and replace the top or rip the whole thing out and start over this is what I get for letting some one help do you think it would be safe to shim the whole top every 8 inches say then re screw down the top