mp 40 copys my othe mp's

[Daniel62]

So I have 3 tanks side by side. the ones on the end run reef crest mode, have added a new tank in the middle. I want this one on constant mode. When I set the mp to this mode it will stay there for about 3 mins, but then goes to reef crest mode. Is it reading the other mps? and if so I do I get it not to.

Thanks

 

[Alex Y EcoTech]

Daniel,

Do you have the pumps in a master/slave relationship? If not, the pump should not change modes unless you are using the buttons or the ReefLink to control them.

 

[Daniel62]

I guess that's my ?. how do I get it out of the slave mode.

Thanks

 

[Alex Y EcoTech]

I guess that's my ?. how do I get it out of the slave mode.

Thanks

You will need to soft reset the controller. To do this, hold down "Mode" and "Set" until the pump flashes red/white and blue. From there, hold "Mode" until red/purple then finally "Set" until the controller turns solid green.

 

[Daniel62]

Thanks