Mp10 Bearings Help

[rffanat1c]

So I bought a used noisy MP10 that came with two bearings. One smaller than the other. However when going to put them on, the smaller one's inner diameter was too big. I've determined the larger one is a 607ZZ 7mm bore x 19mm outside diameter with a 6mm width.

Now on my 2011 MP10, this bearing fits perfectly on the shaft so I need a bore diameter of 7mm. What I can't find on google is which outside and width diameter I need. I'm thinking I need a 687ZZ, 7x14x5. Looking for help on confirming this as I don't think ecotech will tell me. Thanks.

 

[username in use]

Have you asked ecotech? They may tell you.

 

[rffanat1c]

No because threads are littered with they won't. I suppose I can ask, can't hurt

 

[rffanat1c]

Figured it out after sifting through a 19 page mp40 fix and several Google combinations.

 

[rffanat1c]

And FYI this was ecotechs response. "Thank you for contacting EcoTech Marine. Unfortunately, we do not have that specific information as we do not replace any component within the Dryside casing. If you are in need of a new MP10ES Dryside, you will have to call in and speak with a representative to purchase one.

Thanks,

JR Toth
Customer Service Rep"

 

[reefwiser]

Have you upgraded the pump to QD this stopped on bearing noise on my pumps

 

[rffanat1c]

I have not. Not planning on it with this pump, it's for a friend.