I recently cleaned my MP10 wet side for the for the first time (and was shocked to see the buildup on the rotor!). Since putting it back in the tank there is a loud "clunking/knocking"noise. At a 100% speed it gets a little quieter, but when it ramps down it gets louder.
The two sides are aligned as best as I can get them but it is noisier than before for sure.
If I power up the dry side without the wet side it is as quiet as always so I am assuming it is an issue with the wet side.
When I took the unit apart, the square ceramic washer was loose and not stuck to the wet frame with axle as shown in the video here:
http://www.youtube.com/watch?v=tdbF40zM0Ek
Is the washer supposed to be affixed to the frame or is it supposed to be loose and could that be the problem?
Thanks
The two sides are aligned as best as I can get them but it is noisier than before for sure.
If I power up the dry side without the wet side it is as quiet as always so I am assuming it is an issue with the wet side.
When I took the unit apart, the square ceramic washer was loose and not stuck to the wet frame with axle as shown in the video here:
http://www.youtube.com/watch?v=tdbF40zM0Ek
Is the washer supposed to be affixed to the frame or is it supposed to be loose and could that be the problem?
Thanks
