MP40 not staying paired/synced?

[Joeb1983]

I have 2 mp40's with upgraded Quite Drivers paired running anti-sync.

For some reason my slave pump keeps reverting back to the lowest speed and staying there no matter what mode I place the master in.

The dial remains orange indicating slave relationship and the "W's" are lit on both drivers, but like I said; it stays at the 1st dot speed making one side of my tank dead for flow.

This used to happen once in a while and I would simply cycle power and all was well.

Now its taking a hard reset and re-pairing which will last a week or so.

RF modules are correctly and securely installed as well as all connections.

Drivers are ~ 5.5 ft apart in cabinet.

Any ideas? Did it again today...

 

[Alex Y EcoTech]

Joe,

Have you tried running the slave pump in 'Sync" mode to see if it operates correctly?

 

[Joeb1983]

Thanks for the reply Alex!

No, I have not tried sync. Always anti-sync with these QD drivers.

However, with the white ES drivers; I've ran synced before without issue.

Right now I just have them running independent.

I can sync them today after work and see how that works no problem, but in the long run I'd prefer anti-sync obviously.



Thanks again!

Joe