The power supply to my MP40w got wet and stopped working. My wet side was in bad shape as well so I ordered a new wet side along with a new power supply. Now my issue is that the driver only blinks red. I tried holding down the mode button until it flashes white and following the rest of the steps to get it working again but it won't stop blinking red. I tried unplugging and plugging in again with no results. I'm at a loss here. The driver never got wet just the power supply and had been working flawlessly before. Any help would be appreciated.
MP40w blinking red
- Thread starter dave540
- Start date
Alex Y EcoTech
RC Sponsor
Dave,
It sounds as though you may have purchased or been sent the incorrect power supply. I would recommend comparing the new power supply with your damaged one to see if you received the same model.
It sounds as though you may have purchased or been sent the incorrect power supply. I would recommend comparing the new power supply with your damaged one to see if you received the same model.
