New Reeflink- Cannot Locate MP10wQD

[clowninaround74]

I just purchased a Reeflink in hopes to use it with my two MP10wes that I recently upgraded to a MP10wQD. The Reeflink is set up, connected to ESL and the ring of LED's is blue, but in ESL, the MP10's cannot be located. I have tried powering down both pumps and turning them back on and nothing.

I tried searching online and everything I can find is to update the firmware for the non QD drivers. I am totally lost here...

Can anybody help me to get these connected so I can start using the Reeflink with them??

Thank you

 

[Alex Y EcoTech]

Randall,

I would recommend performing a reset on both VorTech controllers. Additionally, please make sure you moved the RF Module or "Wireless chip" from the old ES controllers and installed on the new Quiet Drive controllers. Please follow the steps below to reset your controllers:

1) With the controller powered on, press and hold the "Mode" and Set" buttons until the dial blinks Red, White and Blue.
2) Press and hold the "Mode" button until dial blinks Red and Purple.
3) Press and Hold the "Mode" and "Power/Option" buttons until the pump powers off and resets.

 

[muzzelfuzz]

I 2nd checking for the RF module to actually be in there. I made that mistake when I traded my fx130 gyre for a mp10wes. Long story short the RF module wasn't in the driver, I just ended up spending $95 on a wqd driver that had the RF module. I can't believe how quiet the wqd had made the mp10.

 

[clowninaround74]

Randall,

I would recommend performing a reset on both VorTech controllers. Additionally, please make sure you moved the RF Module or "Wireless chip" from the old ES controllers and installed on the new Quiet Drive controllers. Please follow the steps below to reset your controllers:

1) With the controller powered on, press and hold the "Mode" and Set" buttons until the dial blinks Red, White and Blue.
2) Press and hold the "Mode" button until dial blinks Red and Purple.
3) Press and Hold the "Mode" and "Power/Option" buttons until the pump powers off and resets.

The reset worked perfectly and everything is up and running now. Thank you!