Pab problem

[michaelangello]

Hi, I tried to update the firmware on my Powerbar 6-D PAB through the serial port on my P3 and the installation failed. The green power indicater led is flashing on the powerbar but there is no communication.

Ive tried doing a PAB System Reset and even re-installed the firmware on my P3 but there is still no communication.

My Vortech Controller was still working so I tried updating the firmware on it too which also failed and now it is not working either. When I go to assign devices it says there is none. This is driving me crazy!

 

[michaelangello]

It fails at the "Transmitting Firmware File" The box says "Erasing Flash" and then another box pops up and says "Error While Transmitting Firmware"