I have four vortices....three with the WWD and one with the Ecosmart drivers.
I am trying to get the new ecosmart driver on to my apex system. I have tried everything I can think of, but the new driver never gets detected. The old ones do every time.
I have disconnected the WXM from the apex, I have deleted the WXM, cleared all the driver memories, in all kinds of combinations. The end result is always the same.....the WXM gets detected, and it reads the three older WWD drivers, creates the outlets, etc.
The problem is the ecosmart driver. It will not show up on the WXM.It flashes blue/green as if it is a slave, but then it locks up in this state and never hooks on to the system like the rest of the pumps.
The last thing I did was disconnect all the pumps, deleted the WXM, then it was detected again by the apex, with NO pumps linked to it. I went through the linking process with the newer ecosmart driver....it appeared to be communicating with the wxm but then locks up flashing blue green and the wxm doesn't see it.
Help?
I am trying to get the new ecosmart driver on to my apex system. I have tried everything I can think of, but the new driver never gets detected. The old ones do every time.
I have disconnected the WXM from the apex, I have deleted the WXM, cleared all the driver memories, in all kinds of combinations. The end result is always the same.....the WXM gets detected, and it reads the three older WWD drivers, creates the outlets, etc.
The problem is the ecosmart driver. It will not show up on the WXM.It flashes blue/green as if it is a slave, but then it locks up in this state and never hooks on to the system like the rest of the pumps.
The last thing I did was disconnect all the pumps, deleted the WXM, then it was detected again by the apex, with NO pumps linked to it. I went through the linking process with the newer ecosmart driver....it appeared to be communicating with the wxm but then locks up flashing blue green and the wxm doesn't see it.
Help?
