Programing for Kalwasser Reactor

[Dog Hair]

I use 50 ml dosing pump due to top off reservoir being above sump. Trying to get pump to come on at 8:30 PM and go through cycle of one minute on and nine minutes off every ten minutes until 2:00 AM when we will have a one hour pause to stir and then settle Kalk. Repeat operatior starting at 3:00 AM until 8:30 AM. Another pump will take over top off duties during daylight. Switch two is safety switch for the old top off system to protect from overflo. This timing is calculated to take care of PH/Ca/ and top off issues. Second set of commands is for mixing cycle on Kalk. I assume these goes into advanced outlet program area. I fear i am combining two type of commands that don't work together.

Dosing Pump Outlet:

Fallback OFF
Set OFF
OSC 001/009 On/Off Then ON
If Time 20:30 to 2:00 Then ON
If Time 2:01 to 2:59 Then OFF
If Time 3:00 to 8:30 Then ON
If PH>8.35 Then OFF
If Switch Two Open then OFF


Kalk Reactor Mixing Pump Outlet:

Fallback OFF
Set OFF

If Time > 19:30 Then ON
If Time > 19:32 Then OFF
If Time > 2:01 Then ON
If Time > 2:03 Then OFF
If Time > 8:30 Then ON
If Time > 8:32 Then OFF

Trying to learn this stuff so please don't assume that something is typo and if there is a better way to write this send me to area where I can get the information I need to do it correctly.

 

[swearint]

Yes, you will need to use advanced mode. You were on the right track, but have jumbled a few things. You have also mixed in old syntax from the previous ACx series. The OSC command for the Apex has three intervals and since it provides both ON and OFF conditions, the Set OFF is unnecessary.

[Dose_Pump]
Fallback OFF
OSC 000/001:00/009:00 Then ON
If Time 08:30 to 20:29 Then OFF
If Time 02:00 to 02:59 Then OFF
If pH > 8.35 Then OFF
If Switch2 OPEN Then OFF

[Kalk]
Fallback OFF
Set OFF
If Time 19:30 to 19:32 Then ON
If Time 02:00 to 02:02 Then ON
If Time 08:30 to 08:32 Then ON

Todd

 

[Dog Hair]

Thanks a lot. Feel safer now.