Anyone here with experience with this skimmer? Can't seem to dial it in. I thought it was good. Pulling lot's of gunk, then I cleaned it and it stopped pulling. Bubbles were way down the neck. So I just left it. Figured it would go back up, but it didn't.
Recently added ozone which is running thru the skimmer. Since then it has completely overflowed. So I dialed it back. Then it went way too far down. Left it and after a while went about an inch from the neck. The next day it was 8" below the neck again.
Tomorrow morning, I might find it back up again, or overflowing.
This thing is crazy. No idea what the deal is. Been running for over a month now so it should be broken in by now.
Any input would be awesome.
Recently added ozone which is running thru the skimmer. Since then it has completely overflowed. So I dialed it back. Then it went way too far down. Left it and after a while went about an inch from the neck. The next day it was 8" below the neck again.
Tomorrow morning, I might find it back up again, or overflowing.
This thing is crazy. No idea what the deal is. Been running for over a month now so it should be broken in by now.
Any input would be awesome.
