Hey everyone,
I picked up a used 180 and am redoing the interior seal since it was ragged and dry. The structural seams on the tank are perfect, except this anomaly on one seam. It doesn't extend to the edge and a leak test confirmed that the tank does not leak. What I was wondering was if this anomaly is something I should be worried about going forward? I'd rather not remove panes since I'm no tank builder, but if it looks compromised, then I may have to. It's on a vertical seam in the back, so I was also thinking I could maybe do the glass strip reinforcement if that might work. I also could be making a mountain out of a mole hill, here.
What are ya'lls thoughts?
Sent from my SM-G935V using Tapatalk
I picked up a used 180 and am redoing the interior seal since it was ragged and dry. The structural seams on the tank are perfect, except this anomaly on one seam. It doesn't extend to the edge and a leak test confirmed that the tank does not leak. What I was wondering was if this anomaly is something I should be worried about going forward? I'd rather not remove panes since I'm no tank builder, but if it looks compromised, then I may have to. It's on a vertical seam in the back, so I was also thinking I could maybe do the glass strip reinforcement if that might work. I also could be making a mountain out of a mole hill, here.
What are ya'lls thoughts?
Sent from my SM-G935V using Tapatalk
