RMS mounts

[reefer roman]

I have a couple of RMS mounts with attached radion xr30 pros on a pair of 93 rimless cubes. The problem I have is I can't get the light to level out when tightened to tank. The mount wants to tilt inwards. Is there a way to adjust the mount to have light level. Any inputs would help. Thanks

 

[Cdodge1]

I have the same issue. I don't think there is anything that can be done...but I'm curious to see if anyone has any solutions...

 

[muzzelfuzz]

Same issue here also, send all the ones I've seen lean inward.

 

[u4ick]

Truthfully the 30's are just too heavy to have such a small mounting surface area.

The best way, some might not like the look, but I think it's nice.....is to do the multi light mount system. You will need a total of 2 tank mount and arm, then you get the track length you need for your tank, and then a multi light slide for the # of lights. The makes a mount that you can hold up and lock in place those sagging arms, put a little tension on it too.
This will be rock solid.
But like I said, some don't like the look, prob rimless folks especially as it might take away that hovered over look like the rear mount does.

 

[TheReeferer]

Take the small black rubber cap for the bolt, stick that at the bottom of the chuck between the chuck and glass. Tighten, -- this will give it exactly enough angle to keep the 30 horizontal..

 

[u4ick]

Take the small black rubber cap for the bolt, stick that at the bottom of the chuck between the chuck and glass. Tighten, -- this will give it exactly enough angle to keep the 30 horizontal..

Thanks for your input, I will give this a try myself next chance I get...