Small Piece of acrylic

[dzones]

Is there anyone here who could possibly make/cut a small piece of acrylic for a corner style overflow? Essentially a single piece of acrylic.
Measurements would be:
8" Wide x 9 7/8" tall
grooves could be say 3/4"(ish) along the 8" width.

I figured this would probably be pretty simple, especially for someone who had pieces already kicking around. I don't really care if it is clear or black. Just pm or post me a price.
I was kinda hoping to have it for the frag swap when I could pick it up.
Thanks!

 

[yankeereefer]

Are you looking for something in a 90 degree angle or are you gonna install it diagonally in the corner? If diagonally, You get a piece of acrylic or even glass cut and do it yourself. You don't really need the notches in the overflow, IMO you get better surface skimming with a straight edge. If you're worried about critters going over it, you can cut eggcrate to fit in the overflow. I've setup overflows like this before with no problem. What size tank is this going in?

 

[dzones]

I was just going to put in on the diagonal so by what you are saying I could just go with a straight piece than. I have just done/had the notched for so long I didn't really think of the eggcrate solution.

It is a 48 x 18 x10, frag tank really but it will house some, but not many, critters

 

[yankeereefer]

I be got some scrap acrylic someplace - not sure if it's at home or at my in laws. Will check this evening and post back on this thread

 

[dzones]

Thanks guys for the help and offers. Richard is gonna look after it for me
:celeb3: