Stand leveling suggestions

[kirtdog]

Hi all,

I set up my 75 in the basement and have found that it is way out of level. It appears that the floor is graded to direct water to a floor drain. I tried to put shims under it but it is almost up about 1/4". I think that is way too much. Anyone have any suggestions on what I can do?

I guess I could move it upstairs if needed but I chose to put it in the basement due to the weight and the locations where it would fit upstairs go parallel with the joists and I am not sure that it would be sitting on two of them.

here is a pic of the levels. it doesn't look like much but when filled with water, the water level is about an inch higher on the left side.

 

[kirtdog]

i decided to just move the tank upstairs.

 

[Fizz71]

BTW...If you ever decide to move it back into the basement and you're dealing with a cement floor you can very cheaply level it out with patio blocks and concrete. Kinda of like a faux concrete floor only you can remove it if you need to by chipping it up. I have my 100g sump leveled that way. My floor grade was so steep it took two different thinkness of blocks.