trying to get a bulkhead out

[darb85]

sorry for the posts here but i need to get this out so I can see if tractor supply has the right size.

gah.

When I try to loosen the nut the whole damn thing spins. what are my options on getting this out. flipping the tank is not an option. and space is limited. tryed grabbing the center but it didnt work.

any tricks?

 

[ToddG.]

your going to have to get something on the thread side to hold it channel lock or something even if you mess up the threads dnt worry once you get the nut back far enough you can cut it off or try to get over the messed up threads i had one that had silicone on the threads and it was a pain especially where it was located

 

[macktab]

try a dremel tool with cutting disk, though the nut

 

[darb85]

try a dremel tool with cutting disk, though the nut

basicly did this with a hack saw. got it off. thanks!



not pretty