Want to use two (6000) streams and wave box with controller 7095.

[druluv]

How do you connect the wave box to the 7095. When I tried to directly connect the wave box to the 7095 it started making micro-bubbles. Please help

 

[Armando]

you need to plug the "slave" cable to the wavebox. you also need to change the jumper settings inside the wave controller. check the manual, it explains it really well.

 

[druluv]

Is there an online verison of the wave box instructions; I lost my manual.

 

[mmmmsushi]

Wait a sec. You can connect the Wave box to your Steam Controller? Holy cow. I think I was doing the guy thing and not looking at the directions.

So the Slave line from the Wavebox controller goes into which port on the Stream Controller?

 

[mmmmsushi]

ok, the slave line goes to the wave box. where does the master line go?

 

[blgreef]

I would assume to the small controller that came with the wavebox.

 

[MSHUR]

u dont use slave cable,...just run it separate
use 7095 with 2x 6000 and wave box just with a 7091 controler...

mike

 

[Kiah]

Hello Roger,
I'm interested in seeing your response here as well. My understanding is thatI would:

change the jumper inside the 6091 to <extern>
Plug the slave cable into a channel 1 plug on the 7095

Set the 7095 to interval mode (both channels 1 + 2?????)
Plug both 6000's into channel 2?????? or one in each??

Set the interval to 6 hours

How about the pulse and power - any suggestions???

Thanks