ReefEze
Active member
whatsup everyone
I'm thinking on fitting one or two waveboxes (tunze or DIY) into a ~200g tank that I am planning. Since I will not be home often and others will be doing most of the mundane stuff, I'm erring on the side of caution and reliability rather than performance.
Anyway, my quandry is that I figure that an overflow should be located near the center of a tank when a wavebox is used, so theres not excessive splashing and gurgling and noise. However, this tank is going to be viewed from front and back (maybe a side as well). Any ideas how I can overcome this problem?
TIA
I'm thinking on fitting one or two waveboxes (tunze or DIY) into a ~200g tank that I am planning. Since I will not be home often and others will be doing most of the mundane stuff, I'm erring on the side of caution and reliability rather than performance.
Anyway, my quandry is that I figure that an overflow should be located near the center of a tank when a wavebox is used, so theres not excessive splashing and gurgling and noise. However, this tank is going to be viewed from front and back (maybe a side as well). Any ideas how I can overcome this problem?
TIA
