BigAl2007
Active member
Ok I'm up the the point of trying to set-up/access my P3 remotely. I like to think I'm fairly knowledgeable in regards to Computers in general but I'll admit the remote access portions are puzzling to me. So here is what I have
Here are the screens that I'm puzzled on
A) System Screen (self explanatory)
B) LAN Properties Screen (No idea what needs to be input here)
C) Webserver Admin Screen (pretty simple yes?)
D) Port Forwarding Input screen for my CISCO E1200 Router
So basically what information am I missing and where do I locate the information I'm missing?
1) Port Forwarding - What "Application Name" (If I pick TFTP Ext port 69, Internal Port 69, Protocol UDP, To IP Address 192.168.1.0 are all entered automatically. Do I need to change these settings?) I suppose I need to check the box labeled "Enabled" as well correct?
2) In the LAN settings(pictured below) - What do I need to input and where? Where do I get the info to go in there?
- P3 connected to my DAP-1522 Bridge connected to my WLAN and accessing the P3 inside my WLAN from my laptop.
- No email configured yet
- No webserver configured yet.
Here are the screens that I'm puzzled on
A) System Screen (self explanatory)
B) LAN Properties Screen (No idea what needs to be input here)
C) Webserver Admin Screen (pretty simple yes?)
D) Port Forwarding Input screen for my CISCO E1200 Router
So basically what information am I missing and where do I locate the information I'm missing?
1) Port Forwarding - What "Application Name" (If I pick TFTP Ext port 69, Internal Port 69, Protocol UDP, To IP Address 192.168.1.0 are all entered automatically. Do I need to change these settings?) I suppose I need to check the box labeled "Enabled" as well correct?
2) In the LAN settings(pictured below) - What do I need to input and where? Where do I get the info to go in there?
