Where to get Glass Cut

[chem368]

I'm curious as to where people go in the Valley to get glass cut to size. I want to add a couple baffles to my sump to better adjust water level control. I've used acrylic in the past, but since this whole sump is glass I wanted to stick with that.

Any thoughts?

I need two pieces
1 - 10" X 16 7/16"
1 - 8" X 16 7/16"

 

[saltyguy]

I just built my sump out of a 75 gallon aquarium. I went to National Glass and Mirror. 623-933-8203. I paid $50 for 5pieces of 1/4inch glass. He couldn't drill a hole for me though. I had to buy my own bit and do that myself.

 

[chem368]

Thanks for the lead. I've drilled holes before if I need to, but these should be straight forward baffles.

 

[saintsnsinners]

I use arcadia glass in mesa.

 

[dburt520]

If you're on the west side I had good luck with Bell Glass. I bought 4 baffles (obviously cut to size), 1/4 in, and my total was 30$. I built my sump out of a 40b, so baffles were roughly 17 in wide.

 

[chem368]

Thanks for all the options. I placed an order with Bell Glass and they said they would have it ready 3 hours later. Pretty impressive in my book (or they either have a lot of excess inventory or it was a slow day). Either way I was pleased.

Mine also came to $30, so would not be surprised if there is just a minimum order price as they have to cut a stock piece of glass to size, and it is low volume work. I pick it up this afternoon so hopefully everything comes out as ordered (or more importantly, I hope I measured correctly).